I found a way to reduce glare on HID PnP kits. Results may vary.
Normally, the return wire (insulator colour may vary, mines grey) sits at the bottom, however if you insert the HID bulb so it sits like below, then it should reduce the glare.
![Image]()
![Image]()
Left side before:
![Image]()
Left side after:
![Image]()
Right side before:
![Image]()
Right side after:
![Image]()
Normally, the return wire (insulator colour may vary, mines grey) sits at the bottom, however if you insert the HID bulb so it sits like below, then it should reduce the glare.
Left side before:
Left side after:
Right side before:
Right side after:
