8th Generation Honda Civic Forum banner

who shall be 8thCivic ROTM August??

  • danny4327

    Votes: 16 18.4%
  • el.nene.feo

    Votes: 43 49.4%
  • lpgray91

    Votes: 10 11.5%
  • dany08fa

    Votes: 18 20.7%

  • Total voters
    87
  • Poll closed .
Status
Not open for further replies.
1 - 20 of 21 Posts

·
Administrator
Joined
·
71,985 Posts
Discussion Starter #1
:police:


there is to be NO DISCUSSION in this thread. just. vote.


feel free to bump the thread with a "voted" post....but nothing else. NO "VOTED FOR _____" posts.

:readtherules:
 

·
Registered
Joined
·
958 Posts







Engine/Performance Modifications
Upgraded Greddy kit
Custom welded IC piping by Ballastic Motorsports
CX-Racing One-sided Intercooler
1000cc injectors
HKS SSQV BOV with purple fin
3-port boost control solenoid
Hondata 4bar MAP sensor
NGK-BKR9EIX spark plugs
Hondata Flashpro tuned by VitViper
NST Pulleys

Wheel/Suspension Upgrades
BuddyClub N+ Coilovers
Ingalls front camber bolts
Skunk2 rear camber arms
17x9 +17 Drag DR-31

Exterior Modifications
Front JDM Type-R Conversion
Quad Projector Retrofit with Demon Eyes
[RL + EvoX-R]
Rear JDM pre-facelift conversion
Rep Mugen lip molded onto rear bumper

Interior Modifications
AEM true boost/EUGO wideband gauges
Red LED footwells
Red/White LED HVAC Swap
Pioneer AppRadio 3 + Raspberry Pi
Fiberglassed subwoofer into spare tire
Amps hidden under driver seat
 

·
Premium Member
Joined
·
608 Posts




Engine:
480hp 310tq
Chasebays engine harness
Skunk2 intake manifold chrome plated
Alternator chrome plated
Idle pulley and base chrome plated
AEM fuel pressure regulator
NGK 9 spark plugs
Skunk2 fuel rail
HONDATA INTAKE MANIFOLD GASKET
P2r TB gasket
P2R FP GAUGE ON RAIL
HASPORT MOUNTS 80a
FULL-RACE MANIFOLD
FULL-RACE DOWN PIPE
FULL-RACE 3 INCH CATBACK
FULL-RACE 4 INCH INTAKE
Turbonetics Godzilla 45mm BOV
PRECISION 6262 TURBO
PRECISION 46MM WG
PRECISION 750HP INTERCOOLER polished
CUSTOM VIBRANT INTERCOOLER PIPING
CUSTOM WG DUMP TUBE
CUSTOM FUEL RETURN SYSTEM
ID1000 INJRCTORS
400 WALBRO FUEL PUMP
Competition stage 4
Carbon fiber cooling plate
Carbon fiber side plates
Candy blue valve cover
Arc spark plug cover

Suspension/wheels/brakes:
Skunk2 coil overs v2
Skunk2 rear camber arms
Cusco front strut bar chrome plated
Skunk2 rear lower tie bar
22mm Progress rear sway bar
32mm Eibach front sway bar
Arp extended studs f&r
Kicks neo chrome
Ssr sp3 18x9.5 +18 sbc 0 DISK
Fallen azenis 225/40/18
Brembo custom machined slotted rotors f&r
Stop tech brakes
Stop tech brake lines f&r

Exterior:
Black H jdm badge
Vis carbon fiber mugen rr hood
Vis carbon fiber jdm trunk spoon style
Inner trunk lights converted to brake lights also
Mugen rr front bumper modified for big intercooler
Mugen rr fender flares
Type r side skirts
Type r rear bumper
Csx tail lights
09 civic clear headlights
Dual color switchback white/amber turn signals
4700k ultra white HIDs
09 civic hybrid mirrors

Interior:
Bride racing seats front w/ carbon Kevlar
Bride rear seats upholstered
Bride shift boot
Bride armrest
Type r slide bin gloss black
Corbeau 3inch 5 point harness
Corbeau seat rails
Hybrid limited edition 520 grams shift knob
Two stage 2 short shifter
Hybrid shifter bushings
Xlr8 gauge pod gloss black
Center console gloss black
Aem boost gauge
Aem air fuel gauge
Aem volt gauge
Strutking dead pedal
Weather tech floor mats

Audio:
Alpine head unit
Clarion eq
3 Rockford 8 inch speakers custom deck in suede
2 Rockford tweeters custom box gloss black in rear arm rest
2 Rockford 6 1/2 speakers doors
2 12 inch kickers L7 custom trunk
Kole audio 12 farad lightning cap
Lanzar OPTI 700x2 for highs
Lanzar OPTI 2000x1 mono block
Oddesy mini battery front
Optima yellow top back
 

·
Registered
Joined
·
510 Posts
2011 Honda Civic LX [BAGGED]





Engine/Performance Modifications
JDM R18 Engine Cover
Ralco RZ R18 Pulley Kit
Custom R18 Heatshield
Fujita Short Ram Intake
Custom Boso Exhaust with Skunk2 Resonator
PSWJDM Battery Tie Down
Boomba Racing R18 Motor Mounts

Wheel/Suspension Upgrades
Skunk2 Camber Kit V2
Ksport Airtech Suspension Front Air Struts
Dorbritz Design Rear Bags with Ksport Rear Struts
VIAIR 400C Dual Performance Compressors
Airlift AutoPilot V2 Digital Management System
Polished Specialty Suspension Seamless Aluminum Air Tank 24"
Enkei Aluminum RFP01 Wheels (Silver finish) 205/40/R17

Exterior Modifications
HFP Front Lip
JDM Red Badges
Putco Jet Yellow H11
HFP Rear Underspoiler
Dual Trumpet Air Horn
JDM Yellow Fog Lights
Perfect Fit Hood Guard
Mugen Ventilated Visor
KPlayGround Rear Visor
JLC 6000K 35W Xenon HID
Berlina Black Front Grille Trim
Nokya Hyper Yellow 9005 Bulb
Tuf-Shield Smoke Flat License Plate Cover
JLC 5-SMD SMT T10 Wedge Light Bulbs for License Plate

Interior Modifications
Dash Cover
Hood Insulator
Rear Cupholders
Blue Stitched Boot
Polished Metal Knob
Strut King Pedal Set
CSX Center Consoles
Interior Illumination Kit
OEM Fog Light Button Kit
Broadway Rearview Mirror
Hi State Custom Trunk Setup
Tint (20% Side 5% Rear 5% Strip)
Blue Stitched Leather Steering Wheel Cover
JLC Blue Custom Fitted Map and Dome Lights
JLC 5-SMD SMT T10 Wedge Light Bulbs for Trunk

http://www.8thcivic.com/forums/car-builds/341297-lpgray91s-daily-2011-rbp-fa1-warning-picture-heavy.html
 

·
Registered
Joined
·
1,062 Posts






Exterior-
-FD2 front conversion
-FD2 rear conversion
-vis "mugen style" hood
-vis "demon" trunk
-mugen front lip
-mugen side skirts
-mugen rear diffuser
-mugen window visors
-J's racing air ducts
-cf door pillars
-puddle lights

Interior-
-recaro pole seats
-buddy club seat rails
-nardi steering wheel
-works bell hub
-TWM shift knob

Engine/Performance-
-injen CAI
-K&N air filter
-hondata FP
-type R valve cover
-cf sparkplug cover
-mugen oil cap
-mugen cat back
-NST pullies
-P2R fuel rail
-P2R IMG
-ixiz hood damper
-skunk2 short shifter
-corsport shifter base bushings

Suspention/Wheels-
-accuair e-level
-dorbritz designs fa5 air stuts/bags
-dorbritz designs "kapsel"
-dual viair 444 compressors
-5gal aluminum air tank
-CCW classics 17x9.5 +6 215/40
-falken 912 215/40/17
-DBA front slotted rotors
-skunk2 pro-c rear shocks
-skunk2 rear camber arms v2

Custom Mods-
-custom body work on all 4 fenders
-re-spray fiji blue
-shaved front plate mount
-A,B,C pillar dye
-headliner rewrap (suede)
-cut, shaved, painted intake manifold
-throttlebody coolent bypass

BUILD THREAD- http://www.8thcivic.com/forums/introduction-pictures/461778-daniels-bagged-mugen-si.html#post14227450
 
1 - 20 of 21 Posts
Status
Not open for further replies.
Top