8th Generation Honda Civic Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
76 Posts
Discussion Starter #1
Hey everyone. So I got my skunk2 lowering springs, went to install them, got the front done, and now I'm having issues breaking the bolts loose in the bottom of the rear struts. Maybe it's just because my pos battery powered impact doesnt have the balls, I might try to do it at work with my bad ass air powered snap-on impact. But I was wondering if anyone had any ideas on this? My last civic the bolts were seized and I had to cut them out and get new struts, I reeeeeaaally hope this isn't the case here!
 
1 - 3 of 3 Posts
Top