8th Generation Honda Civic Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
I am repairing a 2010 lx which was involved in a front end collision. The radiator support bar and was bent in the collision so I am replacing this part. However, I want to make certain that the support assembly is not bent out of specs. The support assembly seems to be bent in slightly because the support bar was hit in the collision.(see attached pictures) The support assembly isn't mangled, but it may be off by 1/2 inch and I wouldn't know until I reattach the body panels and hood.

My question is - how can I be certain that the support assembly is returned to the proper specs (location) once I replace the radiator support bar?

242073
 
1 - 1 of 1 Posts
Top