8th Generation Honda Civic Forum banner
  • Hello Everyone! Let us know what you would spend a $50 Amazon gift card on, HERE For a chance to win a $50 Amazon Gift Card!
1 - 2 of 2 Posts

·
Registered
Joined
·
579 Posts
Discussion Starter · #1 ·
My injen filter is getting old and i figure its probably a good idea to replace it sometime soon.

i've been reading up on the apexi filters and want to buy one as a replacement.

looking at the pictures, its kind of strange.. do i need some sort of connection to make it fit to the injen piping?

it doesn't seem like i can just use a strap and tie it down...

also, what mm... 80mm im assuming?

thanks.
 

·
Premium Member
Joined
·
10,300 Posts
80mm is about 3 inches. I think the Injen is 2.75 inches. Bit I could be wrong. I had an AEM CAI, that was 2.75. I think you need a 75mm. But like I said I could be wrong on that. Measure the outside diameter of the piping. If it's 3 inch then yes, it's 80mm.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top