8th Generation Honda Civic Forum banner
  • Hello Everyone! Let us know what you would spend a $50 Amazon gift card on, HERE For a chance to win a $50 Amazon Gift Card!
1 - 3 of 3 Posts

·
Registered
Joined
·
3,490 Posts
Discussion Starter · #1 ·
I have an 07 FA5, I installed the Progress rear sway bar yesterday and Corsport endlinks on the car and was wondering if it matters how exactly the endlinks are positioned after you install them. I am talking about does it matter if they are completely upright and vertical or can they be on a slant somewhat? All the bolts are tightened and the bar and endlinks both seem fine but I was curious if I did it wrong? I aligned it up as close to as the OEM setup looked like as I could.
 

·
Registered
Joined
·
2,885 Posts
I dont know much about endlink setups but if it fits and it drives fine then you probably installed it properly. I always trip out over my DIY installations for a few days until I realize I reaped the benefits of the part. Give her a test run and see how it goes.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top