8th Generation Honda Civic Forum banner
Cancel

Manual transmission series, swaps and compatibility info needed

495 Views 4 Replies 2 Participants Last post by  Chaos Pilot, 
A
I have an 08 coupe exl with a 5 speed manual transmission. A piece of my bellhousing broke off and I’m struggling to find the bell housing and or a transmission that will fit. I have an r18A1 motor with the stock transmission.
what are the different series transmissions?
what series am I / compatible with?
what can I swap with ?
Reply
Save
Like
1 - 2 of 5 Posts
A
A buddy of mine broke it off somehow when helping me separate the trans I’m at a loss for words
Automotive tire Bicycle part Rim Wheel Spoke

Automotive tire Motor vehicle Bumper Vehicle Rim
e
Automotive tire Wood Motor vehicle Rim Bicycle part

Automotive tire Vehicle brake Crankset Motor vehicle Automotive design

Chaos Pilot said:
Can you repair the break with JB Weld? I have seen it used in exhaust manifolds and never fails. Do you have a picture?

If it is a piece with a bolt hole you can build it up with JB then cut threads and use the bolt. Dont overtighten bolt. Go a little under recommended foot pounds.
Click to expand...
See less See more
4
Reply
Save
Like
1 - 2 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
8th Generation Honda Civic Forum
We’re a community for 8th Gen 2006 - 2011 Civic owners to discuss performance mods, body kits, Si models, turbo kits and accessories. Come Join the club!
Full Forum Listing
Explore Our Forums
Introduction & Pictures Garage Mechanical Problems & Technical Chat Inside and Out Civic Si
Top