8th Generation Honda Civic Forum banner

Major Problems after CAI & FlashPro

7152 Views 17 Replies 8 Participants Last post by  sparksk20
Hey guys,

I installed my skunk2 intake today (took almost 5 hours), I must say the instructions given are absolutely terrible ... there is nothing about re-arranging the harnesses or anything about the battery ground wire. Anyways I filled the rad up and let the car run with the cap loose ... uploaded the flash after everything was put back together and walah the car runs like a dream.

Fast foward 3 minutes down the road, my temp gauge is almost at the max ... I pull over and put more antifreeze in it. Head back to the shop and check it again ... kept putting more in and watching the rad slowly take it in. I let the car run again with the cap loose and checked for leaks ... nothing except for when I kept spilling. I put the stock tune back on because the rad fans were not turning on as well.

I finally decided to go home as I was completely fed up, the temp guage reached a little past the middle mark which is a tad above what im normally seeing. Now I have a CEL light on, the odometer is going backwards and the rad fans are not turning on.

The car was smoking by the time I got it home (temp guage read a tad above half) but it was likely from all the spilled coolant heating up in the engine bay.

Can anyone provide some insight on this? Im going to check the coolant yet again in the morning and try pulling the battery cable.
1 - 1 of 18 Posts
I had a similar issue when I installed my hybrid racing intake. To resolve it I let the car run in my drive way with the heat on high and let the rad fan come on twice. I shut the car off and let it cool down and topped up the coolant. After that I was good to go, no overheating.
1 - 1 of 18 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.