8th Generation Honda Civic Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
577 Posts
Thats a bit strange... I just put this intake on my FG2 and I had no problems with the fitment of that sensor... It was a little snug but I gently twisted till it slid into place... and tightened it all the way down with the screws.

it SHOULD fit perfectly. Make sure something isn't sitting inside the tube and obstructing it from going all the way in. I doubt there is but you never can tell.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top