8th Generation Honda Civic Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
389 Posts
Discussion Starter · #1 ·
I just installed my SRI fujita intake on my 06 SI. Car was hot so i did not use that coolant hose but instead just left the old one on which i dont think should be a problem.

But while trying to install the map sensor on the fujita intake pipe, the map sensor could not go all the down, it looks like its on there ok and a bit of the o-ring on the sensor is showing........I wanted to know if anyone else has had this problem?


the sensor is more than 3/4 of the way down, but its not sitting flush.

Thanks!
 

· Registered
Joined
·
389 Posts
Discussion Starter · #8 ·
yes I got the MAP and MAF sensor mixed up, i meant the MAF. The first person that responded knew what i was talking about and problem is all solved now.


Is it ok that i left th original coolant hose on? I did not change it at the time of replacing the intake b/c the car was still kind of hot
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top