8th Generation Honda Civic Forum banner

Status
Not open for further replies.
1 - 20 of 24 Posts

·
Registered
Joined
·
14,808 Posts
Discussion Starter #1 (Edited)
Sold
Up for sale is the bottom end I used on my turbo si. It has less than 8k miles since the rebuild. It has 86mm (stock sleeves) 10:1 compression JE FSR pistons designed for turbos/nitrous, Manley Turbo Tuff rods rated at 1000+hp, ACL race bearings (rod and mains), polished z3 crank, modified type-s oil pump, and ARP head studs which were only torqued down once and I used ARP ultra torque lube so they are certainly reusable. The block is in perfectly fine shape and never gave me any problems. I am selling because I have parted out all my turbo stuff because I got tired of breaking transmissions. This block paired with a simple GT30r setup and 4.3 FD in the trans powered my car to an 11.51 at 122 on pump 93. The block cost me over $2,200 to have built between the price of parts and machine shop labor. For all this I am asking $1800 + shipping OBO, please don't hesitate to make an offer, worst I can say is no. More pictures will be taken upon request.


 

·
Registered
Joined
·
14,808 Posts
Discussion Starter #5
I wish I could afford to buy this. It's only a matter of time before mine blows up.
I have a feeling it will be for sale for a while, so if you do get the funds, LMK. I will be turning it over by hand every week or so to keep it in good shape.
 
1 - 20 of 24 Posts
Status
Not open for further replies.
Top