8th Generation Honda Civic Forum banner
1 - 1 of 1 Posts

182 Posts
Discussion Starter · #1 · (Edited)
installed my injen but had a quick question.
when i removed the wheel well lining, at the bottom there was a piece of plastic which i am assuming is for when u are parking so u dont drive up too far. Well, its held in the middle with a 10mm bolt, and two odd bolts on the two sides.

How do I remove those two bolts, without breaking them, and put them back into place.

Thanks in advance.
And I wish i had a pic of it...
1 - 1 of 1 Posts