8th Generation Honda Civic Forum banner
1 - 9 of 9 Posts

·
Registered
Joined
·
5,705 Posts
Discussion Starter · #1 ·
Hi, i receive my engine torque damper in the mail the other day and was reading the instructions that come with it,(i have the weapon R torque damper, only one made for the R18) and i notice the first 3 steps on the instructions say this..

1. jack up the front of the vehicle, place jack stands under vehicle.
2.place a piece of wood on the top of the jack, slowly jack up the engine from the oilpan..
3.raise up the jack till it is snug against the oilpan..

Now my question is, after reading the DIY for the Si torque damper made by ingalls, i don't see the guy placing jacks to raise up the motor on the Si.. i was wondering if the Si instructions said to do the same or is this only for the R18?


Thanks for your help in advance..
 

·
Registered
Joined
·
1,451 Posts
well i seen someone with it and it doesnt replace the mount but on his the bracket already snapped
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top