8th Generation Honda Civic Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter #1 (Edited)
What you'll need:
- Sheet metal

- Sheet Metal Sheers

- Rubber Molding found on Ebay (Search 120" Car Auto Rubber Seal Strip Door Edge Trim Molding)

- Drill

I think this is pretty self explanatory so I'll just upload my diagram and photos I took during the process. See below:

06-11 Civic SRI Heat Shield.jpg
IMG_0367.JPG
IMG_0369.JPG
IMG_0402.JPG
IMG_0495 small.jpg

Note: I didn't mark the holes on the diagram, I just sort of eyeballed where they needed to be cut. I also don't have access or experience with welding, so that may be a smart additional step. I also rigged a hanger piece out of scrap sheet metal to secure the heatshield to a bolt to the left of it, which I didn't take pictures of.
 
1 - 1 of 1 Posts
Top