8th Generation Honda Civic Forum banner

1 - 2 of 2 Posts

·
Premium Member
Joined
·
21,034 Posts
Discussion Starter #1 (Edited)
basically i need measurements from the edge of the flange to where the flexpipe ends.. (where the brown weaves end). if anyone or sponsors has one sitting around or if someone has it and can look under their car with a measuring tape and can measure it for me than ill gladly give some rep.. planning on welding on a HFC but i bought the DCRH used and cut off so i need the length. and for the DCRH would i need a 2.5 inlet for the HFC (bigger than outlet on headers) or 2.25 so better flow?

help out here guys.. i know some people have done that here too..
 
1 - 2 of 2 Posts
Top