[Superq99]

I have a cold air intake that goes next to my tire and i don't have fender lining. I was driving and it started raining really hard and my engine stopped and was jerking really bad. I limped it home after cleaning the intake letting it dry and using micro fiber to dry the intake pipe (There was a puddle in the cold air intake pipe). My car started but before i turn it on again i was wondering if i should clean anything before i do. Any suggestions help thanks

Edit: a very little amount of water came out and I also replaced the spark plugs. Also added the aem bypass

 

[Beefed88]

1. Remove cold air
2. Install stock air box
3. Remove spark plugs and crank out any residual water
4.install plugs

 

[Superq99]

1. Remove cold air
2. Install stock air box
3. Remove spark plugs and crank out any residual water
4.install plugs

Thanks

 

[kish-81]

1. Remove cold air
2. Install stock air box
3. Remove spark plugs and crank out any residual water
4.install plugs

5. Install fender liner

 

[Superq99]

5. Install fender liner

5. Install fender liner

Already ordered them and a aem bypass for the intake

 

[FD7683]

If the Piston Connecting Rod didn't bend during the incident, you will be safe. Remove the intake filter, then all 4 spark plugs, and crank the hell out of the engine until no water comes out.