8th Generation Honda Civic Forum banner

Brake Booster rod adjustment after Brake Master Cylinder replacement

1650 Views 3 Replies 2 Participants Last post by  FD5
Hello Guys and Girls! I have got a question for you. Does anyone know the gapping spec between our Brake master Cylinder rod and the brake booster push rod? Anyone has experience adjusting them? What is the best method to do so?

I have replaced my CSX's (similar to Civic Si in the US) master cylinder but found the pedal is both soft and engaging relatively low towards the floor. I know it might be air in the line, so I am going to bleed them again, but just wondering if I needed to check the booster rod gapping to see if it is good. I have used an OEM unit so I am not sure if it is set to to Honda MFG spec??

Please let me know what you think.

1 - 1 of 4 Posts
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.