Progress Sway Bar/Corsport Endlinks...

Doeboy211 · 12-02-2007, 11:34 AM

I have an 07 FA5, I installed the Progress rear sway bar yesterday and Corsport endlinks on the car and was wondering if it matters how exactly the endlinks are positioned after you install them. I am talking about does it matter if they are completely upright and vertical or can they be on a slant somewhat? All the bolts are tightened and the bar and endlinks both seem fine but I was curious if I did it wrong? I aligned it up as close to as the OEM setup looked like as I could.

CanyonDriver · 12-04-2007, 02:53 PM

I dont know much about endlink setups but if it fits and it drives fine then you probably installed it properly. I always trip out over my DIY installations for a few days until I realize I reaped the benefits of the part. Give her a test run and see how it goes.

Toxis · 12-04-2007, 02:59 PM

Pics will tell...

12-02-2007, 11:34 AM	#1 (permalink)
Doeboy211 Senior Member Join Date: Jul 2007 Location: Queens, NYC Posts: 680 Rob iTrader: 3 / 100%	Progress Sway Bar/Corsport Endlinks... I have an 07 FA5, I installed the Progress rear sway bar yesterday and Corsport endlinks on the car and was wondering if it matters how exactly the endlinks are positioned after you install them. I am talking about does it matter if they are completely upright and vertical or can they be on a slant somewhat? All the bolts are tightened and the bar and endlinks both seem fine but I was curious if I did it wrong? I aligned it up as close to as the OEM setup looked like as I could.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Progress Sway Bar Special!!!	Excelerate	Excelerate Performance	299	08-13-2009 10:37 AM
progress rear sway and....	dnbsi	Suspension and Brakes	4	11-06-2007 11:41 PM
Problem with the Progress Sway Bar on an 07 SI Sedan.	SIis4ME	Civic SI	7	04-17-2007 02:34 PM
Progress rear sway bar and stock endlinks	pengful	CorSport	16	04-04-2007 02:25 PM

12-04-2007, 02:53 PM	#2 (permalink)
CanyonDriver Senior Member Join Date: Nov 2007 Location: Culver City Age: 21 Posts: 2,882 Taylor Kurtz iTrader: 0 / 0%	I dont know much about endlink setups but if it fits and it drives fine then you probably installed it properly. I always trip out over my DIY installations for a few days until I realize I reaped the benefits of the part. Give her a test run and see how it goes.

12-04-2007, 02:59 PM	#3 (permalink)
Toxis Senior Member Join Date: Sep 2006 Location: A Star of Death. Age: 30 Posts: 3,916 Luke... I have cookies! iTrader: 11 / 100%	Pics will tell...