power loss?

micyj30 · 02-08-2008, 02:59 PM

So heres the story, i had an AEM CAI and the tube got a crack after 2 years and it set of my Check light. So i took it out and while i was doing that i broke the Air Assist valve(cheap plastic and cold weather i guess). I bought a Fujita ram air but i have seem to have a power loss and my gas millage went to the shitter.... also my check light is still on and the code is intake air temp.
could this be from the air assist valve and also any ideas y i have power loss?
thanks

Ass Turtle · 02-08-2008, 03:52 PM

did you reset your ECU?

micyj30 · 02-10-2008, 03:04 PM

******bump******

FG-JOE · 02-10-2008, 03:13 PM

heat soak could be a factor.

02-08-2008, 02:59 PM	#1 (permalink)
micyj30 Senior Member Join Date: Mar 2007 Location: schaumburg,il Posts: 101 mike iTrader: 1 / 100%	power loss? So heres the story, i had an AEM CAI and the tube got a crack after 2 years and it set of my Check light. So i took it out and while i was doing that i broke the Air Assist valve(cheap plastic and cold weather i guess). I bought a Fujita ram air but i have seem to have a power loss and my gas millage went to the shitter.... also my check light is still on and the code is intake air temp. could this be from the air assist valve and also any ideas y i have power loss? thanks

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
hfp muffler power loss?	Rphsidan	Bolt-Ons And All-Motor	0	11-08-2007 05:37 PM
Mods = loss of power	PaulShoe	Civic SI	37	11-04-2007 05:25 PM
Loss of HP?	j0ntar	Mechanical Problems & Technical Chat	12	10-31-2007 02:11 PM
Fujita SRI power loss?	si_turbo	Bolt-Ons And All-Motor	59	08-14-2007 03:40 PM
Noise at 4500 rpm - only when in gear - some loss of power - (no it's not vtec)	SeanInLACA	Mechanical Problems & Technical Chat	4	11-21-2006 03:34 PM

02-08-2008, 03:52 PM	#2 (permalink)
Ass Turtle Senior Member Join Date: Jan 2008 Location: Greenvile NC Posts: 226 iTrader: 0 / 0%	did you reset your ECU?

02-10-2008, 03:04 PM	#3 (permalink)
micyj30 Senior Member Join Date: Mar 2007 Location: schaumburg,il Posts: 101 mike iTrader: 1 / 100%	****bump****

02-10-2008, 03:13 PM	#4 (permalink)
FG-JOE Senior Member Join Date: Oct 2007 Location: North of the Grapevine Age: 20 Posts: 3,921 Joseph iTrader: 33 / 100%	heat soak could be a factor.