Help with wiring for Halo Projectors

[bignewegg]

Hello I recently purchased a set of halo headlights from autocity.

2006+ Honda Civic (2dr) Halo Projector Headlights (G1 Black)

I would like some help with the wiring for the lights themselves. What connections go where and where do the wires without an end go? they look like speaker wire with a bare end on them. If this has been done in another thread please post a link to it.

Thanks.

[darrman25]

tap into your park light wires with them.

[striker_1818]

Remember to know which wire is positive and which wire is negative.
black color is a dead give away for negative.

[bignewegg]

ok i think i can do that. one more question. one of the sockets, namely the third one didn't come with a light bulb. what is that bulb used for? do i take out a light from the stock lights and place it in?

[striker_1818]

what third socket?
you have two halos that can be tapped into the parking lights
You have three sockets:
- One for the turn signal
- One for the low beam
- One for the high beam

[Cr8tive_leo]

Cutting park lights wire?

[bignewegg]

on the link for autocity, if u look at the 2 halo lights to the left right before the turn signal you have another socket. in the picture u can see a white sticker covering the hole that says remove. if u enlarge the picture on autocity it is on the top right corner.

[striker_1818]

thats the turn signal socket. So, yes, you replace them with your stockies

[bignewegg]

thanks that is exactly what i was thinking.

[sanjcee]

I have a pair of projectors too, but my prob is that the halo's don't light up and that the high beam bulb keeps flickering.. what am I doing wrong?