2006+ Honda Civic Interior Tear Down Guide - Page 3

ssoh87 · 02-21-2008, 04:34 PM

subscribed

bakk · 03-05-2008, 10:27 PM

I NEED HELP!! I've taken apart my dash following the steps in this thread 07 Full audio system install (updated as I have time)

but the problems that I cant get the two bolts/screws out that are above the pocket next to the aux input and cig lighter.. In the guide it says to use a 9mm socket, but for the life of me, that doesnt fit! is it that I have a bad socket?? Should i try a friends set?? What size are they? Can anyone say 100% what size is needed? Thanks!!

**CameronJr9** · 03-06-2008, 10:21 AM

Quote:

Originally Posted by bakk

I NEED HELP!! I've taken apart my dash following the steps in this thread 07 Full audio system install (updated as I have time)

but the problems that I cant get the two bolts/screws out that are above the pocket next to the aux input and cig lighter.. In the guide it says to use a 9mm socket, but for the life of me, that doesnt fit! is it that I have a bad socket?? Should i try a friends set?? What size are they? Can anyone say 100% what size is needed? Thanks!!

You also can use a phillips screwdriver. Get in under there and look for yourself. Should work.

Good luck!

Hostage46 · 03-27-2008, 05:01 PM

Do I need a special tool to remove the clips? I'm going to try to install a Parrot once I get up the nerve....

McKennr · 04-13-2008, 12:33 PM

Quote:

Do I need a special tool to remove the clips? I'm going to try to install a Parrot once I get up the nerve....

Nope, just muster up some heart and pull with intent.

It takes the same about the amount of effort as crushing a beer can X number of clips.
so if the panel has 4 of them... then it takes good effort.

A piece like the back deck or door panels you need to do in parts (like one or two at a time across the part)

Locate the clip in you mind from the pic's and pull hard and fast about 1-3 inches or 4-8 cm, not much more is needed .

Bartling08 · 04-16-2008, 01:59 PM

I need help with removing the door handle, not the door latch that opens the door but the actual handle below it. Any suggestions?

**CameronJr9** · 04-16-2008, 02:58 PM

Quote:

Originally Posted by Bartling08

I need help with removing the door handle, not the door latch that opens the door but the actual handle below it. Any suggestions?

Like so?

DIY Front Door Handle Removal

jrsobtec · 04-26-2008, 08:58 PM

Hey Guys I just installed a new radio in my car, but I need to rewire the to front speakers. I can't get thes panels out. Little help please.......

Thanks

J

**CameronJr9** · 04-27-2008, 07:24 AM

Quote:

Originally Posted by jrsobtec

Hey Guys I just installed a new radio in my car, but I need to rewire the to front speakers. I can't get thes panels out. Little help please.......

Thanks

J

Front Speaker Install

wildnfld · 05-27-2008, 12:45 PM

hey guys, looking for some help in trying to repair or minimize a dent in my car. would rather not pay a grand. Does anyone know how to remove the interior armrest/ molding on the rear of the coupe? if so. can you see the outside skin of the car. or is it reinforced and closed off? the dent is rocker panel of car.. behind door. in front of tire.. help please

xvoltm2 · 05-27-2008, 01:03 PM

Great thread...subscribed.

jdmlov3r · 05-31-2008, 01:02 AM

Quote:

Originally Posted by revv13k

tried removing the center part of the dash on my friends civic the other day, and had no success.

i'm guessing this

is how you remove it?

is this the same procedchure for a dash with a navi.

**CameronJr9** · 05-31-2008, 08:21 AM

Quote:

Originally Posted by jdmlov3r

is this the same procedchure for a dash with a navi.

Pretty much, yeah. Be sure to get those bolts underneath first.

jdmlov3r · 06-02-2008, 02:29 AM

wut bolts and how do u move the left side of the panel.

**CameronJr9** · 06-02-2008, 09:49 AM

In the picture you just posted, near the bottom it says "bolt." Those are the bolts.

Click here, you'll see the full dash removal. Follow steps 6-11.

TcivicT3 · 06-04-2008, 02:54 PM

i cant see the first 4 pics of the dash removal and i can't download that link ^

**CameronJr9** · 06-04-2008, 03:05 PM

Quote:

Originally Posted by TcivicT3

i cant see the first 4 pics of the dash removal and i can't download that link ^

You can't download it due to restrictions where you are? Or you can download it, but you can't open it?

If you can download it but can't open, use this program.

Then, try again.

TcivicT3 · 06-04-2008, 04:12 PM

got it. thanks

***Special Ringpop*** · 06-05-2008, 04:52 AM

What about door panels on a coupe.

I've had them replaced twice, and the idiots can't seem to fix the ****** things. They squeak like an old grandfather chair, and none of the god damn clips seem to want to hold them in.

**CameronJr9** · 06-05-2008, 09:23 AM

Quote:

Originally Posted by Special Ringpop

What about door panels on a coupe.

I've had them replaced twice, and the idiots can't seem to fix the ****** things. They squeak like an old grandfather chair, and none of the god damn clips seem to want to hold them in.

Take a look here.

Front Speaker Install

04-26-2008, 08:58 PM	#48 (permalink)
jrsobtec Junior Member Join Date: Oct 2007 Location: Weston, Florida Age: 23 Posts: 3 Javier Romero iTrader: 0 / 0%	Help Help Front door panel 07 Si Coupe Hey Guys I just installed a new radio in my car, but I need to rewire the to front speakers. I can't get thes panels out. Little help please....... Thanks J

06-02-2008, 09:49 AM	#55 (permalink)
CameronJr9 Crazy Yellow Puppet Join Date: Feb 2006 Location: Louisville, KY Age: 28 Posts: 25,778 Back and Forth Forever iTrader: 6 / 100%	In the picture you just posted, near the bottom it says "bolt." Those are the bolts. Click here, you'll see the full dash removal. Follow steps 6-11. __________________

LinkBacks (?) LinkBack to this Thread: http://www.8thcivic.com/forums/interior-style-mods/8972-2006-honda-civic-interior-tear-down-guide.html
Posted By	For	Type	Date
Untitled document	This thread	Refback	06-03-2008 05:11 AM
4D comfort	This thread	Refback	05-19-2008 12:25 PM
2006 Civic LX Sedan. Alpine IVA-D300, 12w7, 1000/1, Rainbow SLC 6.5	This thread	Refback	02-04-2008 01:12 PM
Honda/Acura SIRIUS interface SL2H - Page 4 - VAIS Technology Forum	This thread	Refback	01-31-2008 12:30 AM
2006+ Honda Civic Interior Tear Down Guide - 8th Generation Honda Civic Forum	This thread	Refback	01-28-2008 01:19 PM
Honda/Acura SIRIUS interface SL2H - Page 4 - VAIS Technology Forum	This thread	Refback	01-27-2008 12:03 AM
Honda/Acura SIRIUS interface SL2H - Page 4 - VAIS Technology Forum	This thread	Refback	01-17-2008 03:02 PM
2006+ Honda Civic Interior Tear Down Guide - Page 2 - 8th Generation Honda Civic Forum	This thread	Refback	01-16-2008 12:44 PM
Honda/Acura SIRIUS interface SL2H - Page 4 - VAIS Technology Forum	This thread	Refback	12-16-2007 10:10 PM
Honda/Acura SIRIUS interface SL2H - Page 4 - VAIS Technology Forum	This thread	Refback	12-06-2007 03:09 AM

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
The Where is the Car I Want Thread - ANY STATE	cbondhonda	New Car-Buying Information	336	09-22-2008 11:46 PM
Grace: 2006 Honda Civic Si ASM	PWRDByAdobo	Introduction & Pictures	67	01-24-2008 07:24 PM
Memorial Day Thread	webby	Water Cooler	31	05-28-2007 09:38 PM
Kind of interesting - Honda Chronology 1946-2005	webby	Water Cooler	4	10-04-2006 09:39 PM
2006 Honda Civic Hybrid Pricing Released	webby	Honda Industry News	0	11-30-2005 10:08 AM

02-21-2008, 04:34 PM	#41 (permalink)
ssoh87 Senior Member Join Date: May 2007 Location: Denver Posts: 201 Sunny iTrader: 0 / 0%	subscribed

03-05-2008, 10:27 PM	#42 (permalink)
bakk Junior Member Join Date: Jan 2008 Posts: 5 iTrader: 0 / 0%	I NEED HELP!! I've taken apart my dash following the steps in this thread 07 Full audio system install (updated as I have time) but the problems that I cant get the two bolts/screws out that are above the pocket next to the aux input and cig lighter.. In the guide it says to use a 9mm socket, but for the life of me, that doesnt fit! is it that I have a bad socket?? Should i try a friends set?? What size are they? Can anyone say 100% what size is needed? Thanks!!

03-27-2008, 05:01 PM	#44 (permalink)
Hostage46 Member Join Date: May 2006 Age: 46 Posts: 96 iTrader: 0 / 0%	Do I need a special tool to remove the clips? I'm going to try to install a Parrot once I get up the nerve....

04-16-2008, 01:59 PM	#46 (permalink)
Bartling08 Junior Member Join Date: Apr 2008 Location: Bismarck ND Posts: 1 Mitch iTrader: 0 / 0%	I need help with removing the door handle, not the door latch that opens the door but the actual handle below it. Any suggestions?

05-27-2008, 12:45 PM	#50 (permalink)
wildnfld Junior Member Join Date: Feb 2008 Posts: 17 iTrader: 0 / 0%	hey guys, looking for some help in trying to repair or minimize a dent in my car. would rather not pay a grand. Does anyone know how to remove the interior armrest/ molding on the rear of the coupe? if so. can you see the outside skin of the car. or is it reinforced and closed off? the dent is rocker panel of car.. behind door. in front of tire.. help please

05-27-2008, 01:03 PM	#51 (permalink)
xvoltm2 Senior Member Join Date: Jun 2007 Location: NJ Posts: 2,057 iTrader: 10 / 100%	Great thread...subscribed.

06-02-2008, 02:29 AM	#54 (permalink)
jdmlov3r Senior Member Member Join Date: May 2008 Posts: 132 iTrader: 0 / 0%	wut bolts and how do u move the left side of the panel.

06-04-2008, 02:54 PM	#56 (permalink)
TcivicT3 Senior Member Join Date: Jan 2008 Location: Chicago Posts: 590 iTrader: 0 / 0%	i cant see the first 4 pics of the dash removal and i can't download that link ^

06-04-2008, 04:12 PM	#58 (permalink)
TcivicT3 Senior Member Join Date: Jan 2008 Location: Chicago Posts: 590 iTrader: 0 / 0%	got it. thanks