question about jdm emblems on sedans

JDMish · 06-09-2007, 12:12 AM

Searched but couldnt really find a clear anwer.. i ordered the FA5 jdm emblems from passwordjdm.com. I know the rear emblems you need to cut the pegs off. But do you need to cut off the pegs for the front emblem as well? I tried to install it but the pegs dont line up and the emblem itself is a bit too big. Any input is appreciated

zen · 06-09-2007, 12:42 AM

Yup, you have to cut off the pegs. They won't line up.

PeterC. · 06-09-2007, 01:07 AM

Second that. They aren't plug and play. You will have to match it by eye over the front grill.

JDMish · 06-09-2007, 01:32 AM

cool, thanks guys

06-09-2007, 12:12 AM	#1 (permalink)
JDMish Junior Member Join Date: Mar 2007 Posts: 15 iTrader: 0 / 0%	question about jdm emblems on sedans Searched but couldnt really find a clear anwer.. i ordered the FA5 jdm emblems from passwordjdm.com. I know the rear emblems you need to cut the pegs off. But do you need to cut off the pegs for the front emblem as well? I tried to install it but the pegs dont line up and the emblem itself is a bit too big. Any input is appreciated

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Honda car codes FG2, EP, etc.?	GlennS	Garage	14	02-27-2008 01:29 AM
JDM Rice Test	FujiBlueSi	Water Cooler	13	12-11-2007 01:59 AM
Where to buy???? Emblems JDM	07mugencivic	Inside and Out	2	04-18-2007 10:04 PM
conversion is done ...	sickyute	Introduction & Pictures	428	03-30-2007 11:30 PM
Any non-red 'H' emblems for sedans? If not, then: Go Reflective Tape Guy!	ABM JDM	Inside and Out	4	02-20-2007 02:00 AM

06-09-2007, 12:42 AM	#2 (permalink)
zen Senior Member Join Date: Apr 2007 Location: Virginia Beach, VA Posts: 155 zen iTrader: 1 / 100%	Yup, you have to cut off the pegs. They won't line up.

06-09-2007, 01:07 AM	#3 (permalink)
PeterC. Senior Member Join Date: May 2007 Location: SoCal Age: 23 Posts: 233 iTrader: 0 / 0%	Second that. They aren't plug and play. You will have to match it by eye over the front grill.

06-09-2007, 01:32 AM	#4 (permalink)
JDMish Junior Member Join Date: Mar 2007 Posts: 15 iTrader: 0 / 0%	cool, thanks guys