can someone tell me what is needed for the rear CSX conversion

[Pwnstar]

ok so iv looked and looked on here and all i can find is what you need to do the front csx conversion and im wanting to do the rear, can somone tell me what all is needed ? do i just need the trunk and tail lights and im good to go? or so i need the tails, bumper, trunk, harnes and bumper supports and crap lol i hope its just the easy way.

[laok1d]

Tail lights and Trunk lid and your set.

Bumper is optional.

[Milzy]

u need the tail lights and trunk as stated above the bumper is recommend seeing it has a very small size difference compared to the stock FA1/5 bumper and the bulb sockets need to be either modified my shaving a piece off or replaced. you also need to extend the wires for the reverse lights from the quarter to the trunk case the csx/jdm swap has the reverse lights on the trunk compared to the usdm's on the lights on the quarters. im pretty sure thats everything.

[Pwnstar]

ok cuz i really dont wanna have to buy a bumper lol because i was just gonna get a cf trunk from ebay and some stock tails and be done. doing the wires is not a problem either thats what i had to do on my Fit extend the wires and mod. the sockets thats nothing but if i need a bumper im gonna pass that would make it out of my price range i think. the bumper im sure is alot and then getting it painted :/ and i dont wanna have a gap between the bumper and the tails.

[ajax]

there was a thread i remember seeing on this somewhere here

Found it!

DIY: JDM rear end Conversion