Power to trunk EX Coupe

SleepingEclipse · 11-27-2007, 04:48 PM

I have been searching for days and can't find an answer on this one. What's the best way? Everything I have found deals with the sedans and not the coupes. If someone else can find it then let me know and if this has been asked before I'm sorry. Just trying to find the cleanest way to run power to the trunk. I have an 07 EX coupe mt w/navi.

lostdaytomorrow · 11-27-2007, 05:14 PM

Driver's side fender well

07NHBCivicSi · 11-28-2007, 12:41 PM

How do I get Power to the Trunk?

If you dont have a plug were that DIY states...put a hole in the rubber boot were all the wires are going through..i did that by cutting a little hole and then getting a long flathead and shoving it through.

11-27-2007, 04:48 PM	#1 (permalink)
SleepingEclipse Junior Member Join Date: Jul 2007 Location: Millbrook, IL Posts: 27 Lucas iTrader: 0 / 0%	Power to trunk EX Coupe I have been searching for days and can't find an answer on this one. What's the best way? Everything I have found deals with the sedans and not the coupes. If someone else can find it then let me know and if this has been asked before I'm sorry. Just trying to find the cleanest way to run power to the trunk. I have an 07 EX coupe mt w/navi.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
^SO-CaL SQUAD_UP!^	Dessa_8837	California South	281	05-27-2008 10:04 PM
how much of a pig is your car? weight list	webby	Garage	20	05-01-2008 01:30 PM

11-27-2007, 05:14 PM	#2 (permalink)
lostdaytomorrow Senior Member Join Date: Oct 2006 Posts: 734 iTrader: 0 / 0%	Driver's side fender well

11-28-2007, 12:41 PM	#3 (permalink)
07NHBCivicSi Senior Member Join Date: Jul 2007 Location: Walnut Creek,CA Age: 17 Posts: 583 Curtis iTrader: 2 / 100%	How do I get Power to the Trunk? If you dont have a plug were that DIY states...put a hole in the rubber boot were all the wires are going through..i did that by cutting a little hole and then getting a long flathead and shoving it through.