composite manifold or IB ported manifold??

jnaut · 01-27-2008, 09:26 PM

Might be an old topic , i did a search found nothing, sorry if this is the case...
any info on either one. if somebody has the ib manifold have you dynoed it?I dont think the composite has not been released yet.

Highrev1 · 01-27-2008, 09:30 PM

Blueprint Manifold Testing Results - Club RSX Message Board

jnaut · 01-27-2008, 10:24 PM

thanks rev that link is good but i was talking about out stock manifolds being ported?

Highrev1 · 01-27-2008, 10:32 PM

Better

Blueprint Manufacturing - Advance Race Technology - Engine Sleeving and CNC Port and Polish

01-27-2008, 09:26 PM	#1 (permalink)
jnaut Senior Member Join Date: Jun 2007 Location: west palm beach Age: 30 Posts: 183 jason iTrader: 0 / 0%	composite manifold or IB ported manifold?? Might be an old topic , i did a search found nothing, sorry if this is the case... any info on either one. if somebody has the ib manifold have you dynoed it?I dont think the composite has not been released yet.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Go Power Ported Intake Manifold	Driversound	Bolt-Ons And All-Motor	2	11-28-2007 11:17 PM
AJP Ported Manifold 20 WHP Gain	tone6215	Bolt-Ons And All-Motor	173	10-17-2007 11:07 AM
Ported Intake Manifold Question	jdizzle37	Forced Induction And Nitrous	3	02-01-2007 01:49 PM
AJP Ported Intake Manifold Tested...	F.I.A.T	Forced Induction And Nitrous	137	12-26-2006 05:33 PM
NEW:AJP/Port Works Ported Intake Manifold	F.I.A.T	Forced Induction And Nitrous	65	11-29-2006 12:31 AM

01-27-2008, 09:30 PM	#2 (permalink)
Highrev1 Senior Member Join Date: Mar 2006 Posts: 3,710 iTrader: 1 / 100%	Blueprint Manifold Testing Results - Club RSX Message Board

01-27-2008, 10:24 PM	#3 (permalink)
jnaut Senior Member Join Date: Jun 2007 Location: west palm beach Age: 30 Posts: 183 jason iTrader: 0 / 0%	thanks rev that link is good but i was talking about out stock manifolds being ported?

01-27-2008, 10:32 PM	#4 (permalink)
Highrev1 Senior Member Join Date: Mar 2006 Posts: 3,710 iTrader: 1 / 100%	Better Blueprint Manufacturing - Advance Race Technology - Engine Sleeving and CNC Port and Polish