Help gum issue

Chase016 · 07-10-2008, 06:00 PM

Hey everyone. Newish to forum, just recently bought a 08' GG coupe MT. Loving it! So far 2k miles and I noticed today some idiot that was in my passenger seat must have just stepped in gum because theres blue gum on my pass floor mat, and on the side of the column right next to the floor board. Any suggestions on how to get this out? No idea where to start other than hot water, but I dont want it to get that matted dirty look. Its grey interior btw. Thanks in advance.

buffmunky_07 · 07-10-2008, 06:03 PM

same things happened to me man i was so pissed...i used that foamy interior cleaner with the scrubber at the end...with a little elbow grease it looked just as new

RJJensen · 07-10-2008, 07:10 PM

you could try to ice it up get it real cold and hard then hopefully pick it out

***airportguy770*** · 07-10-2008, 07:13 PM

instead of using ice to get it cold, get one of those cans of compressed air. If you flip it upside down, it shoots out some gas that is ice cold. It'll freeze anything on contact.

RJJensen · 07-11-2008, 08:29 PM

Quote:

Originally Posted by airportguy770

instead of using ice to get it cold, get one of those cans of compressed air. If you flip it upside down, it shoots out some gas that is ice cold. It'll freeze anything on contact.

That could work.

07-10-2008, 06:00 PM	#1 (permalink)
Chase016 Senior Member Join Date: Jun 2008 Location: Texas Age: 25 Posts: 224 Brandon iTrader: 0 / 0%	Help gum issue Hey everyone. Newish to forum, just recently bought a 08' GG coupe MT. Loving it! So far 2k miles and I noticed today some idiot that was in my passenger seat must have just stepped in gum because theres blue gum on my pass floor mat, and on the side of the column right next to the floor board. Any suggestions on how to get this out? No idea where to start other than hot water, but I dont want it to get that matted dirty look. Its grey interior btw. Thanks in advance.

07-10-2008, 07:13 PM	#4 (permalink)
*airportguy770* VIP Member Join Date: Jun 2006 Location: Stockbridge,GA Age: 25 Posts: 6,909 David iTrader: 9 / 100%	instead of using ice to get it cold, get one of those cans of compressed air. If you flip it upside down, it shoots out some gas that is ice cold. It'll freeze anything on contact. __________________ sig by MrsJrotax101

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Starting Issue /Ignition issue/ - Merged threads	cornflake	Mechanical Problems & Technical Chat	67	08-19-2008 02:24 PM
another issue with my car again!	Cornizzy	California North	23	06-03-2008 03:33 PM
clearance issue	xxdynhamikxx	Forced Induction And Nitrous	10	04-30-2008 04:55 AM
Alignment issue	SiAzul	Mechanical Problems & Technical Chat	8	09-12-2007 01:56 PM
Another issue for the pot of many.	Special Ringpop	Mechanical Problems & Technical Chat	26	08-28-2007 12:09 PM

07-10-2008, 06:03 PM	#2 (permalink)
buffmunky_07 Member Join Date: Oct 2007 Location: Chicago, Illinois Age: 19 Posts: 60 David iTrader: 1 / 100%	same things happened to me man i was so pissed...i used that foamy interior cleaner with the scrubber at the end...with a little elbow grease it looked just as new

07-10-2008, 07:10 PM	#3 (permalink)
RJJensen Senior Member Join Date: Apr 2007 Location: NJ Posts: 872 iTrader: 0 / 0%	you could try to ice it up get it real cold and hard then hopefully pick it out