Mechanical Defouler

iVTECpower · 02-26-2007, 02:18 AM

I have a 2007 Si (I/RH/E). Are there any mechanical defoulers or O2 sims out there for our car? I need to get rid of my CEL from my DC race header. Anyone else running the DCRH?

Coop · 02-26-2007, 01:28 PM

There is a DIY on here somewhere. Try search

jboogie183 · 02-26-2007, 03:40 PM

You can get them at Auto Zone. I think there is actually a company selling them already drilled.

iVTECpower · 02-27-2007, 09:17 AM

Eh, what I meant to put in my post was pre-drilled. Oh well, I picked some up from an auto parts store. 18mm ones. If I remember correctly I just need to drill one end of one with a 1/2" bit. By the way Coop I used search, sometimes it buggy though. I think I found it now.

02-26-2007, 02:18 AM	#1 (permalink)
iVTECpower Member Join Date: Nov 2006 Location: ID Age: 22 Posts: 63 Ben iTrader: 0 / 0%	Mechanical Defouler I have a 2007 Si (I/RH/E). Are there any mechanical defoulers or O2 sims out there for our car? I need to get rid of my CEL from my DC race header. Anyone else running the DCRH?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
mechanical noise ?	yeppi	Mechanical Problems & Technical Chat	8	05-31-2007 12:55 PM
Flanges for test pipe? plug defouler?	Rallyfocus	Bolt-Ons And All-Motor	0	08-08-2006 02:53 PM
Mechanical Noise around 6000rpm and above	Marin	Mechanical Problems & Technical Chat	11	07-01-2006 03:17 PM
DC race header - defouler cel light mod fix	jdmk20z3	Civic SI	1	04-04-2006 06:28 PM

02-26-2007, 01:28 PM	#2 (permalink)
Coop Senior Member Join Date: Nov 2006 Location: TX Posts: 1,980 Coop iTrader: 7 / 100%	There is a DIY on here somewhere. Try search

02-26-2007, 03:40 PM	#3 (permalink)
jboogie183 Senior Member Join Date: Jun 2006 Location: Frederick, MD Age: 25 Posts: 225 Josh iTrader: 0 / 0%	You can get them at Auto Zone. I think there is actually a company selling them already drilled.

02-27-2007, 09:17 AM	#4 (permalink)
iVTECpower Member Join Date: Nov 2006 Location: ID Age: 22 Posts: 63 Ben iTrader: 0 / 0%	Eh, what I meant to put in my post was pre-drilled. Oh well, I picked some up from an auto parts store. 18mm ones. If I remember correctly I just need to drill one end of one with a 1/2" bit. By the way Coop I used search, sometimes it buggy though. I think I found it now.