Quote:
Originally Posted by quickfit
not bad, but if your gonna do mods for cheap, atleast do them with a littel better quality.
that metal looks like it will bend form the force of the wind when your driving.
get some thicker aluminum, put it in a vice and hammer it to bend 90 degrees.
MetalsDepotŪ - 6061-T6 Aluminum Flat Bar
id say that 1/8" x 1" would be prefect. |
i got excited when i read the first two words
than i realized its always somethin with u ian
Quote:
Originally Posted by Cr8tive_leo
Nice, I picked up angle brackets for 12 cents each to do the same thing (without bending and cutting). They're 5mm thick and won't bend with the force of the wind. If I find them , I'll post pics, if not, I'll go get some more... was going to do that before the first snow. Now it's jsut a little too cold and snowy out.
Nice Diy!
|
first DIY
