8th Generation Honda Civic Forum - View Single Post - DIY: Injen CAI install on R18 (lots of pics)

Nebkhat · 07-20-2009, 10:37 AM

Install went fantastic, thanks for the great write up. I would add one very important step to the beginning of the doc.

Step #1 - After unpacking your CAI use a bath towel to clean the inside of both pipes. Twist the towel through each pipe until you can remove it from the opposite end. Metal flakes may be left in the pipes from machining. Pay close attention to the area where the sensor in mounted.

Thanks again.

07-20-2009, 10:37 AM	#107 (permalink)
Nebkhat Senior Member Join Date: Jul 2009 Location: Gatlinburg, TN Age: 38 Posts: 431 Kyle	Install went fantastic, thanks for the great write up. I would add one very important step to the beginning of the doc. Step #1 - After unpacking your CAI use a bath towel to clean the inside of both pipes. Twist the towel through each pipe until you can remove it from the opposite end. Metal flakes may be left in the pipes from machining. Pay close attention to the area where the sensor in mounted. Thanks again.