First off, if it doesn't come out of a box with this stamp, read no further.
Purchased from Speedtech Racing Developments (
www.speedtechracing.com)
Removed my replica's and cleaned up the sills.
Mugen vs Ebay Replica
Knock Off rear visor (some are not transparent)
Mugen rear visor w/ embed logo & transparent
rear mugen visor. you can see the small hole for the clip.
Knock off front visors. Sharp hard plastic edge at bottom.
Mugen front visor. Has a rubber lip on bottom of visor.
Steps:
1. Clean the door frame w/ the supplied wipe.
2. Pull down the rubber window molding.
You have a total of 8 clips. 2 are different than the other 6.
These 2 seperate clips with the groove goes on the REAR door visor in the hole CLOSEST to the front doors.
(If you do not put these clips on this spot it will not line up properly along the sill).
The rest of the clips (6) will go on as such
3. Line up vents along door frame to get a visual on the fit.
Pay attention to the orange tear away for the tape. All tape
will touch the black sills. This will help you line it up.
When confident on setup, pull orange tape off, support the clips with your
index fingers and edge into place. If the visor sticks to the door when you weren't ready, just give it a firm quick pull, it'l pop right off. Be careful and have patience.
4. Put the rubber window molding back in.
5. Push along the tape line to get a good seal. Open the door
and pinch it tight all along for extra grip.
6. Enjoy!
