Quote:
|
Originally Posted by mrk
The guy in this post used a heat gun to clear his headlights.
I also plan on using a heat gun to clear my headlights too. I'm guessing you just heat up a section then cut the sealant and pry it open a little until you go all the way around. It shouldn't be that hard. I'll try to post up a DIY.
|
Just use the oven. It sounds really intimidating until you try it out. I did mine with Ayenoc today. We did them for 4 minutes at 350. You start prying around the edge with a flathead screwdriver...and then just pull it all apart. It takes about 8 minutes total, including baking. I can see using a heat gun being far more cumbersome and tougher, seeing as how you can only warm up the sealent in one area at a time. The oven gets everything nice and gooey.