[F.I.A.T]

Just a heads up we did test the ported intake manifold we recently released this past week. We tested it on the shop car with our turbo kit. the results were quite promising. What we realized on the drive to the dyno was and increase i both top end and mid rnge torque. When we rolled onto the dyno the results spoke for themselves. The car made the exact same power as before on the last 37owhp pull with roughly 2-2.5 psi less boost. What was the end result was an increase of roughly 8%. We will be testing on a NA vehicle later on this week ime permitting.

FYI the manifold will not be available for use on our turbo kit until more testing can be done. For NA application we have immediate release. The turbo cars are quite a bit more dangerous to go about modding with proper testing and extended driving. NA cars dont require as much drivabilty testing since they run smaller injectors and and dont suffer from the small issues.