8th Generation Honda Civic Forum - View Single Post - DIY ** NST Civic SI underdrive pulleys
Thread: DIY ** NST Civic SI underdrive pulleys
View Single Post
Old 07-03-2008, 01:08 PM   #187 (permalink)
SIcBoy
Senior Member
 
SIcBoy's Avatar
 
Join Date: Jul 2006
Location: peoria az
Age: 27
Posts: 3,648
jr
Quote:
Originally Posted by OrdnanceMarine View Post
If you've replaced all three pulleys and it is lose then you've missed getting the belt routed properly. Make sure it's centered on all pulleys (especially the ribbed ones). I set up the belt on all of the pulleys except for the idler pulley, then pulled the tensioner pulley towards the front of the car and slid the idler pulley with the belt on it over the shaft that holds the idler pulley and threaded the idler pulley bolt in by hand. Then I released the tensioner pulley, tightened the idler pulley bolt and verified the belt was centered correctly on all pulleys.
thanks once again...
yeah i had the belt on the wrong way, but i got it back together
SIcBoy is offline