|
DIY - Schroth Racing Harness install for Sedan (Coupe should be similar)
Quote:
Originally Posted by BlackHFP
Hey everyone - First off I want to say thanks to everyone that provided constructive input on this install. I would not have known to contact Schroth if you all had not spoken up.
I am sad to say that I have requested that this thread be locked and the DIY removed. After speaking with the manufacturer about some concerns raised by other members I have decided to change the install. Once I receive the parts from Schroth and get them installed I will be doing a new DIY.
BTW the install is correct; the stock seat just is not approved by Schroth. They said they are 99% sure that the stock seat can take the forces necessary, but I don't want anyone to do my DIY then have an accident and be in that 1%. I purchased a new strap and will be attempting to convert the harness into a Ralleye 3 (the mount will be on the rear outer pillar.)
Just to reiterate - This DIY was for informational purposes only. I take no responsibility for your install. Please use common sense; you are modifying a factory safety system. If you are unsure of your abilities to complete this install please do not attempt it. Once again installation using my instructions is at your sole risk.
Thank again for everyones input.
Mat
|
diy temporarily removed.... will be updated
Last edited by BlackHFP; 05-12-2008 at 05:48 PM.
Reason: Added the harness type.
|