Quote:
Originally Posted by ortivt6
^hey Do they make an aftermarket HFC short enough to replace the second piece of the BCRH???
|
Yeah there is a HFC that is short enough to fit that can used to replace the test-pipe section but you would need a shop to weld on the two flanges to it. That way you would be able to swap out the HFC if you wanted to run the test-pipe. IIRC that Random Technology is the one because there was a guy who did this over onepahtch a long time a ago.
Quote:
Originally Posted by jsnymeyer
Oh, snap. I figured this was just going to be the springs, but whatever works  |
Essentially it is just the springs because we'll be in essence trading the front setup on my for the front setup on your car. The rears you would be getting just the springs since the spring& strut are seperate.
Joey, I finally installed that applique on my wife's Fit. Looks good & it covered up the gouges/scratches on the bumpercover. Thanks again for that.