Quote:
Originally Posted by Sirbelch
Do you know if the bottom inlet on the CRV box lines up with the stock Si cold air tube?
|
Yes it does Paul. The configuration is the same as the Si. The only difference on the bottom portion of the airbox is that the dimensions are larger. It is about an inch and a half wider and it is quite a bit deeper than the Si box, which poses no problems with installation as there is plenty of space to accomodate it in the Si engine bay.
Once the cowl induction is finally wrapped up, I am going to remove the resonator portion of the factory cold air, run some flexible Spectre Industires tubing down lower, and use a BSR duct near the lower bumper intake. I will then have two areas to pull cold air in from. Originally, I was not going to use the factory cold air and just close that off on the CRV airbox, but after talking to Nasif, aka K20 SDN, he told me there is a strong vacuum pull there. So I will use two inlets for cold air.