umm...ok well i dont know why it quoted everything I just said there but yeah anyways...
OK!! Here's a mini DIY for those interested in wanting to do the Spark Plug covers.
--Please use the same Engine Enamel Paint used on your engine cover. NOT SPRAYPAINT--
1. Go ahead and disconnect the the spark plugs.
2. Then loosen the nut from the bolt and unscrew the cover off. Once untightened you can just unscrew off it with your hand.
3. Now just pull it out.
4. Ok, heres what you wanna tape off on the covers.
A: Place a piece of tape over the connector hole so no paint can leak through and get into it. it doesnt have to be all the way to the edge just because it will be covered when you connect it back. Only make sure the hole is covered completely
B: Cover the top part now.
C: Now go ahead and cover the rest of the cover along the bottom.
5. After have completely taped off all that needs not to be painted, go ahead and use the Exacto Blade and cut out the edge of the tape on the top. The blade fits perfectly in the groove so this is pretty easy. It should look like this.
---Oh, whats not shown here is how I taped off that hole where the bolt goes through..all you do is place a small piece of tape over it and press it down hard...then use the Exacto to cut around the circle and hole then just peel the the edgings cover all the metal, that way there is no paint getting inside that on the metal---
6. Now just follow the steps on painting. Sand away on it but not to deep. then primer it, paint and clear coat those bad boys. Once finished, take the tape off, install them back on the car and they should look something like this.
