Quote:
Originally Posted by pwrful4
I'll take you up on your offer. I'd like a plastic piece that fits in the 125mm x 75mm ellipse (fog light hole) that could be epoxied in. Have it taper to an outlet that is roughly the same diameter as the pipe in this picture. I would remove the resonator box and fender tube and connect this new part to the prexisiting tube.
rough sketch:
 |
re-use the rubber(#13) to place it at the fog light location. I done this on my car(routing air into the air filter) the IAT on my Sri saw a decrease of temperature by 10 degrees on the HDS when I tested my "getto ram intake"
