Step Six:
After the first coat of filler, youll need to sand it down
keeping in mind to watch all the lines youlll want in the pod/dash
trim, this may take a few lighter coats of filler and sanding to get
it all right. Then after the innitial shape has taken place and the
lines all look decent, youll need to use glazing putty for those small
pin holes or creases you couldnt get at with filler. This to will take
some sanding with 200g sandpaper but be gentle on it as it will
go through the putty quick, all you want here is to blend everything
in. Then the first coat of filler primer is needed, this will show even more
flaws in which you can work out afterwards with the glaze putty.
