[Neerbeer]

Hi, I was looking yesterady at the firewall tring to find a good location to run a poower cable from the battary to the truck. I hava two 8" Bazoka subs (one powered and one slave unit) that I want to install. These were left overs from a previous install that I've used for several years in a couple of diffrent vehicles. I've usually been able to find a groument to run the power wire though to get to the back of the car. Yesterday when I was looking I thought I found one on the firewall about center of where the glove box is located on the engine side that would work but I'm not sure where that comes out on the interior side? I dropped the glove box down, looked and felt behind what I believe is the blower motor assembly. Located directly behind the glove box but cound not see where the wire loom is entering the cabin from the engine side.

My question is this. Where have you guys run your wiring? And does anyone have the assembly manual or some installation instructions showing how to remove the dash panels to get to one of these locations so that I can utilize one of them?

Thanks, Brian

06 Alabaster Silver EX Sedan
06 Slate Green Odyssey EX