8th Generation Honda Civic Forum - View Single Post - Pics of my dropped FA5 with Progress Springs

02civicsi · 11-03-2007, 08:37 PM

4ever a Fan of the Man!!!

I also have a Dale Earnhardt plate frame since the day I drove off the lot. I've had the plate frame on my two previous Hondas(EJ6 & EP3). Funny short story about the EP3. I told the salesman I would not drive off the lot in the new EP3 if they didn't put my plate frame on the car, of course they obliged. I did the same thing on the FA5.

So you're saying hell with the rear camber kit & just but two sets of camber bolts? When I installed a four corner camber kit on my old EP3 I always contemplated adding a second set of camber bolts for the fronts. Are there not OEM Honda front strut bolts that will allow one to adjust about + - 1.5 degrees of camber?

11-03-2007, 08:37 PM	#14 (permalink)
02civicsi Senior Member Join Date: Jan 2007 Location: Lonnngwoooood, FL Posts: 8,395 I am the Juggernaut!!! iTrader: 19 / 100%	4ever a Fan of the Man!!! I also have a Dale Earnhardt plate frame since the day I drove off the lot. I've had the plate frame on my two previous Hondas(EJ6 & EP3). Funny short story about the EP3. I told the salesman I would not drive off the lot in the new EP3 if they didn't put my plate frame on the car, of course they obliged. I did the same thing on the FA5. So you're saying hell with the rear camber kit & just but two sets of camber bolts? When I installed a four corner camber kit on my old EP3 I always contemplated adding a second set of camber bolts for the fronts. Are there not OEM Honda front strut bolts that will allow one to adjust about + - 1.5 degrees of camber?