Wire 1. Expose the actual wires. You cannot connect this anywhere. Instead you will have to solder it on to a thick guage baby blue wire located on the bottom most 20 pin connector (maybe not 20 but its a long rectangular one)
Wire 2. Before you plug this in, remove the wire and stick it in the opposite corner. Then plug it in like this:
(Image courtesy of 8thcivic member "mrk")
Wire 3. This one you have to get on your back and look under the dask. Way deep in there, you'll see an open brown connector. Stick there there. While you're at it, position Wire 5 neatly and cable tie it.
Wire 6. Ground wire. You will see a 10mm bolt that is currently holding 2 other ground wires, loosen that and bolt ground wire there.
Wire 4. Switch. Is your case Sedan or Coupe? You should have an open/blank spot on the left side of your dash. Pop the cover out from the inside. Kinda have to squeeze and push.
Hope this helps. There are other members here who have this same harness. I've had a bit of experience with it and I wish I had pictures to help you out but I hope the above helps you for now. Let us know if you need further help
